Ricoh Pro 8300S - Sc754-26

1.SC Codes
518
Pattern
B
Error Condition
While jogging small-size paper, the rear jog fence HP sensor did not go ON, even though the jog fence
motor operated long enough for 60 mm of feed.
Major Cause
 Jog fence rear HP sensor defective
 Jog fence rear motor defective
 Connector loose, damaged, or defective
 Master control board defective
Solution
 Reconnect the connector.
 Replace the jog fence rear motor.
 Replace the jog fence rear HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC754-26
Error Name
Perfect Binder: Jog Fence Rear HP Sensor Lag Error
Pattern
B
Error Condition
While small-size paper was being jogged, the jog fence rear HP sensor did not go OFF after the rear
jog fence motor operated long enough for 40 mm of feed.
Major Cause
 Jog fence rear HP sensor defective
 Jog fence rear motor defective
 Connector loose, damaged, or defective
 Master control board defective