Ricoh Pro 8300S - Sc754-60

1.SC Codes
541
 Signature out of position, snagged on main grip
 Connector harness loose, damaged, or defective
 Slave control board defective
Solution
 Reconnect the connector.
 Replace the MG lift motor.
 Replace the signature exit sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power off/on.
SC754-60
Error Name
Perfect Binder: Main Grip HP Sensor (L) Late Error
Pattern
B
Error Condition
During main grip lift, the MG HP sensor (L) did not go ON, even though the main grip lift motor had
operated for 6185 ms.
Major Cause
 MG lift motor defective
 MG HP sensor (L) defective
 Connector harness loose, damaged, or defective
 Slave control board defective
Solution
 Reconnect the connector.
 Replace the MG lift motor.
 Replace the MG HP sensor (L).
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power off/on.