Ricoh Pro 8300S - Ring Binder: Binder Unit Run-Out Error; Sc756-40

1.SC Codes
568
3. Check the harness.
Check if the harness between the spine clamp motor/clamp HP Sensor and the sub board is
damaged or exposed. If so, replace the harness. Turn the power OFF/ON, and then check if the
SC recurs.
4. Replace the components.
 Replace the spine camp motor.
 Replace the clamp HP sensor.
 Replace the sub board.
SC756-40
Error Name
Ring Binder: Binder Unit Run-Out Error
Pattern
B
Error Condition
 The run-out roller moved from home position, but home position is detected even after a specified
time had passed. (The first time is reported as a jam. An SC is issued the second time this occurs.)
 The run-out roller has moved to the home position, but home position is not be detected within a
specified time. (The first time is reported as a jam. An SC is issued the second time this occurs.)
*First time jam: Pre-punch jogger jam (J343)
Major Cause
 Power of downstream unit not turned on
 Runout press roller motor defective
 Connector disconnected
 Overload
 Runout roller HP sensor defective
Solution
1. Turn the power OFF and ON.
2. Check the connector.
Check the connection between the runout press roller motor / runout roller HP sensor and the sub
board. (Check all the connectors are completely connected.)
If the connector is not connected properly, reconnect the connector. Turn the power OFF/ON, and
then check if the SC recurs.
3. Check the harness.
Check if the harness between the runout press roller motor / runout roller HP sensor and the sub
board is damaged or exposed. If so, replace the harness. Turn the power OFF/ON, and then check