Ricoh Pro 8300S - Page 731

3.Paper Delivery Problems
723
brush.
Procedure 2
 Apply this procedure only when: 1) A back-curl is required to flatten curls with the decurl unit,
and 2) Sheets are delivered with their printed side facing up in the post-processing machine.
1. On the machine operation panel: Adjustment Settings for Skilled Operators > Paper Feed/ Output >
Adjust Paper Curl > Check the current decurl setting (Off, Weak, or Strong). (SP 1-906-001 to 012:
De-curler Setting Tray <number> :Paper Path Selection)
2. Is it "Adjust Convex Curl: Weak" or "Adjust Convex Curl: Strong"?
Yes
Go to the next step.
No
Consult the product specialist.
3. Is this setting essential?
Yes
Go to the next step.
No
Set Adjust Paper Curl to "Adjust Convex Curl: Off" (set it back to the default value).
4. Are the sheets delivered with their printed side facing up.
Yes
Go to the next step.
No
Contact your service representative.
5. Is this setting essential?
Yes
Consult the product specialist.
No
Change the setting so that the sheets are delivered with their printed side facing down.
6. Print the image. Is the problem resolved?
Yes
Finished!
No
Consult the product specialist.