4.Troubleshooting for Peripheral Units
793
Cause
The paper slackens due to the difference in level between the trailing edge fence and stapling stacking
fence, causing misalignment.
Solution
Adjust the position of the trailing edge fence using the SP mode.
The factory-set value is on the sticker at the position indicated by the red frame.
Check the label indicating the initial value.
If the value of SP-6-121-003 (NV Adj. Data Mod.: Staple Stacking Fence) is "0", adjust the position of
the staple stacking fence gradually (for example, +0.2, +0.4, +0.6, . . .), and check if the misalignment is
solved.
If the initial value is not "0", adjust the value in the positive or negative direction to align the staple
stacking fence and trailing edge fence.
To Next Page
Loading...
