4.Troubleshooting for Peripheral Units
835
[B]: This is the front scale for A3
3. Disconnect the stacker from the upstream unit.
4. Remove the bracket [A] of the upstream unit and rotate it to [B] ( x1). Changing the position of
this bracket aligns the oval cut-out horizontally and frees the joint bracket so that it can slide from
side to side.
5. Loosen the screws of the bracket and slide it to the left or right to adjust the position.
6. Dock the stacker to the upstream unit again, print some more sheets, and then check registration
and skew again to make sure that the edges of the sheet do not go beyond the first notch of the
scale.
To Next Page
Loading...
