Ricoh Pro 8300S - Printing Operation after Jammed Paper Is Retracted; The Message about Left Paper Is Shown; To Change the Printing Operation after Jammed Paper Is Retracted

5.Other Information
851
The Message about Left Paper is Shown
Printing operation after jammed paper is retracted
When specific paper jams (J049, J050, J080, and J099) occur, the jammed paper is retracted to the
purge section at the lower left of the machine and printing will continue.
(There are some conditions like paper size, paper type, and paper thickness.)
After the printing job has been completed, the machine prompts the user to remove the retracted paper.
To Change the Printing Operation after Jammed Paper is Retracted
 Confidential documents or other printings that the user wants to hide from other persons may
be left in the purge section. To prevent this, the machine can be configured to prompt the user
to remove the paper immediately after they are retracted to the purge section.
 The machine can also be configured to continue printing without prompting the user to remove the
paper even after the print job is completed.
1. Select "Behavior After Paper Diversion" from [Main Unit: Paper Feed/ Output] group in the
Adjustment Settings for Operators, and then confirm the current settings. (SP mode: SP1-051-001
Behavior After Paper Diversion)
2. Change the settings:
 To prompt the user to remove jammed paper immediately it is retracted: "Suspend"
 To continue printing after the printing job is finished: "Continue Unless Paper Diversion Box
Full"
 To prompt the user to remove jammed paper when the print job is completed: "Continue Until
All Jobs In Queue Complete"
When the purge section becomes full, the machine suspends printing and prompts the user to
remove the paper, regardless of whether the print job has been completed or not.