5.Other Information
854
execution.
7. Do SP2-310-001 – 3rd Execution
Do SP2-310-001 (100 sec.). After this SP executes, check the value of SP2-920-002 (Steering
Control Roller Stable Position of Steering Roller)
If the value is -20 ≤ SP Value ≤ +20, do the next 4th SP execution. At this time the SP value in
Step 4 is not set to “0”.
If the SP value is <-20 or >+20, then the “Steering Plate Adjustment” described below is
required. After this adjustment, set the value for the Step 4 SP to “0”, and then do the 4th SP
execution.
8. Do SP2-310-001 – 4th Execution
Do SP2-310-001 (100 sec.). After this SP executes, record the value of SP2-920-002 (Steering
Control Roller Stable Position of Steering Roller)
9. After doing the 4th execution of SP2-310-001, do one of the following, using the value of the setting
for SP2-920-002 (Steering Control Roller Stable Position of Steering Roller).
If SP value <-20 or +20<SP value: Check the ITB unit, and then reset the ITB belt unit, and
then repeat lubricant application in Step 4.
If -20 ≤ SP Value ≤ +20: Reset the following SP codes to their default settings:
For SP2-310-002 change the "100" setting to "300" to restore the default.
For SP2-920-013 change the "105" setting to "400" to restore the default.
Next, do Steps 10 and 11. If you did not do the adjustment for the right control plate, skip
Steps 10 and 11, and then go to Step 12.
10. Open the controller box. (Field Service Manual > Replacement and Adjustment > Common
Procedures > Controller Box, Controller Box Cover > Opening the Controller Box)
11. Loosen the three screws of the ITB/PTR motor bracket, and then tighten them.
To Next Page
Loading...
