2. In the [Finishing: Finisher 1] group on the [Adjustment Settings for Operators]
menu, select 0632: [Output Fan Setting] to [On].
3. Print the image. Is the problem resolved?
Ye
s
Finished!
When all of the necessary printing is complete, configure [Output Fan Setting]
back to [Auto].
No Go to the next step.
4. Print on a smaller number of sheets. If the problem persists, configure [Output
Fan Setting] back to [Auto] and contact your service representative.
<Tip curling-up>
1. Is it possible to flip the printed side by delivering the paper inverted?
Ye
s
Go to the next step.
No Print on a smaller number of sheets. If the problem persists, configure 0632:
[Output Fan Setting] back to [Auto] and contact your service representative.
2. Press [Output/ Customize Function/ Finisher].
3. Press [Output/ Cstmz.].
4. Press [Rvrse Ejct: FaceUp/Dn].
5. Press [OK].
6. Print the image. Is the problem resolved?
Ye
s
Finished!
No Go to the next step.
7. In [Advanced Settings] for your custom paper being used, adjust the feed speed
for the decurler unit.
8. Print the image. Is the problem resolved?
Ye
s
Finished!
No Go to the next step.
9. Print on a smaller number of sheets. If the problem persists, configure 0632:
[Output Fan Setting] back to [Auto] and contact your service representative.
5. Post-Processing Option Troubleshooting
150
To Next Page
Loading...
