Paper weight Curl amount
Paper Weight 9
Face curl: 10 mm
Back curl: 0 mm
Correcting curl
1. Place the curled surface down on a flat surface.
2. Hold the end of the paper and straighten it in the opposite direction to the curl direction so that
the paper is rounded.
If the separation pressure level has been adjusted
For any of trays 1 to 3, if the separation pressure adjuster has been changed to a non-default
separation pressure, double feeding may occur, depending on the paper type used.
Double feeding can be prevented by changing the separation pressure level back to the default
position.
Is the Pickup Assist setting enabled?
If the Pickup Assist function operates too much, it may cause double feeding with coated paper.
By disabling the Pickup Assist setting, you can prevent double feeding.
The two-tray wide LCT does not have the Pickup Assist function.
<If custom paper is used>
1. Select [Machine: Paper Feed / Output] in [Advanced Settings] for the custom paper in use,
select 1321: [Main/3-Tray LCIT/Bypass] and set [Pickup Assist] to [Off].
<If custom paper is not used>
1. In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, set 03089: [Pickup Assist Setting] to [Off].
Special or coated paper is used.
• Is the airflow strong enough?
The factory-set airflow of the three-tray wide LCT may not be strong enough to separate the sheets.
Increase the airflow.
<If custom paper is used>
1. Select [Machine: Paper Feed / Output] in [Advanced Settings] for the custom paper in
use, select 1301: [3-Tray LCIT] and increase the value in [Fan Level].
<If custom paper is not used>
1. In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, increase the value in 0306: [Wide LCT: Fan Level].
• Is the tab fence attached?
4. Troubleshooting Paper Delivery Problems
86
To Next Page
Loading...
