Ricoh Pro 8310 - Non-Carbon Paper (Thickness 0;1) Are Not Stacked Properly

4.Troubleshooting for Peripheral Units
783
 When attaching the Z-fold support tray, ask the customer to accept the following:
 Alignment accuracy is not assured.
 The maximum stack capacity for the finisher shift tray is 30 sheets. Remove output sheets
from the tray every 30 sheets.
Non-Carbon Paper (Thickness 0/1) Are Not Stacked Properly
Cause
Installing the Z-fold support tray reduces the angle of the tray and helps paper transport. However, as a
side effect, the output jogger is unable to reach the paper surface, causing the horizontal direction of
the paper stack to be poorly aligned.
The width of the Z-fold support tray is 191 mm. When feeding paper of horizontal length of 191 mm or
more, such as A4 LEF, both ends droop from the tray.
Stack accuracy is particularly poor when feeding the side-curled short grain paper in the LEF direction.