4.Troubleshooting for Peripheral Units
784
Attaching the Z-fold support tray reduces the angle of the finisher tray, so the distance between the tray
and the leading edge of delivered paper increases. As a result, it takes time for the trailing edge of
delivered paper to fall. When one end of the output jogger touches the delivered paper, the paper stack
slides to the side, and becomes disaligned.
This is likely to occur it:
ï‚· Paper of Thickness 0 (52.2 g/m2 or less) is used
Output sheet bending or jam error caused by sheet bending (JAM 107/109) occurs.
Frequency: Incidence rate of convex curl is 4/300
Solution
Attach the support plate, and then use the finisher with the extension tray of the shift tray expanded.
If the support plate is attached, ask the customer to change the value for "Output Jog Position Ang Adj"
from "0deg" to "10deg" (SP6-219-001).
To Next Page
Loading...
