Ricoh Pro 8310 - How to Adjust the Folding Deviation

4.Troubleshooting for Peripheral Units
801
The mark indicates the leading edge (relative to the paper feed direction), and the mark
indicates the trailing edge.
How to adjust the folding deviation
This procedure is the same for L1, L2, and L3.
1. Open the front cover of the multi-folding unit.
2. Remove the mounting screw.
If the mounting screw is attached to the adjusting screw hole, unfasten it.
3. Turn the adjusting screw to adjust the deviation.
 To increase the length at the bottom part of paper, turn the screw clockwise.
 To decrease the length at the bottom part of paper, turn the screw counterclockwise.
4. Attach the mounting screw to fasten the adjusting screw.
If the mounting screw is attached to the adjusting screw hole, fasten it.
5. Close the front cover of the multi-folding unit.
 For multi-sheet folding, the folding deviation that appears in the center of paper will be
adjusted.
 If the deviation is large, the paper may be skewed. (Paper Skew)