4.Troubleshooting for Peripheral Units
823
appears).
3. Make sure at least three sheets of paper are set for copying, and then print three sheets.
4. Check the placement of the Trim Pattern on the sheets as shown below.
Image Skewed to the Front
Measure the amount of skew. This is the difference between A and B.
ï‚· Up to four shims stacked at one point can be used to correct paper skew.
If the amount of skew (difference between A and B) is 1 mm and there is only one LCIT RT5120 in the
line, insert two shims at the rear [A] as shown.
If the amount of skew (difference between A and B) is 1 mm and there are two LCITs RT5120 in the
line, insert two shims at the rear [A] as shown on the left side of the upstream LCIT.
To Next Page
Loading...
