Ricoh Pro 8320 - Page 225

1.SC Codes
217
Error Condition
An error is detected at voltage level of 24V_INT_1 (this SC is issued when the error was detected for
the first time).
Major Cause
 The downstream device is not turned on.
 Motor defective
 Broken harness
 Broken controller board
* Protective Device: <FU3>
* Related Components:
 Booklet stack tray motor <DCSM18>
 Shift tray 2 lift motor <DCM03>
 Shift tray 2 shift motor <STM17>
 Shift tray 2 drag roller movement motor <STM18>
 Shift tray 2 drag roller motor <STM19>
 Shift tray 2 press lever motor <STM20>
 Shift tray 2 jogger motor <STM26>
 Shift tray 2 jogger fence retract motor <STM27>
 Shift tray 2 paper exit fan motor (front) <FAN01>
 Shift tray 2 paper exit fan motor (rear) <FAN02>
 Exit guide motor <STM21>
 Shift tray 1 exit motor <DCSM20>
 Shift tray 1 lift motor <DCM04>
 Shift tray 1 shift motor <STM22>
 Shift tray 1 drag roller movement motor <STM23>
 Shift tray 1 drag roller motor <STM24>
 Shift tray 1 press lever motor <STM25>
 Shift tray 1 jogger motor <STM28>
 Shift tray 1 jogger fence retract motor <STM29>
 Shift tray 1 paper exit fan motor (front) <FAN03>
 Shift tray 1 paper exit fan motor (rear) <FAN04>
 Shift tray 1 fan motor <FAN05>
Solution
1. Identifying the defective area
Disconnect each connector of the protection device from the main board of Finisher
SR5110/SR5120 one by one, turning ON the power each time.
2. Identifying the defective component