Ricoh Pro 8320 - Image Quality Problems; Paper Spotted with Toner; Toner Spotting;Staining

2.Image Quality Problems
628
2. Image Quality Problems
Toner Spotting/Staining
Paper Spotted with Toner
Paper has toner spots of 0.5–1 mm (0.02–0.04 inches) in diameter.
Cause:
Toner fragments have slipped through the cleaning web (which cleans the pressure roller) re-adhered to
the paper.
This may occur when:
 Printing on both sides of paper
 Printing on uncoated (especially rough-textured) paper
 Printing a single-dot halftone image
 To adjust the following settings, register beforehand the type of paper that you are using
Solution:
Increasing the temperature when using thin paper with a thickness equivalent to Paper Weight 0 or 1
may cause paper curling, resulting in paper jams at the fusing unit.
1. Raise the temperature by 5°C in Fusing Heat Roller Temperature Adj in Advanced Settings for the
custom paper in use.
2. Print the image. Is the problem resolved?
Yes
Finished.
No
Go to the next step.
3. Raise the temperature an additional 5 °C in Fusing Heat Roller Temperature Adj.
4. Print the image. Is the problem resolved?
Yes
Finished.
No
Go to the next step.
5. Have changes to the settings resulted in glossy lines or paper misfeed?