Ricoh Pro 8320 - Page 663

2.Image Quality Problems
655
Yes
Use different paper.
No
Raise the setting by one point.
12. Print the image. Is the problem resolved?
Yes
Finished.
No
Repeat Steps 11, 12. If this does not solve the problem, go the next step.
13. Open the SC log. Is there a logged SC code?
Yes
If either of the following SC codes were logged, perform troubleshooting:
 SC443-00: Image Transfer Roller Error
 SC453-00: Paper Transfer Roller Error
No
Go to Step 15
14. Print the image. Is the problem resolved?
Yes
Finished.
No
Go to the next step.
15. Is it possible to raise the toner density setting?
Yes
In Advanced Settings for the paper in use, select Adjust Toner Adhesion, and raise the
setting (+).
No
Consult the product specialist.
16. Print the image. Is the problem resolved?
Yes
Finished.
No
Consult the product specialist.
 Adjust the toner adhesion setting carefully. Raising the toner adhesion setting increases the
amount of toner consumption and reduces toner yield.
Rough Images with Paper Smaller Than A4 SEF (210 mm)
The texture of solid-fill areas appears rough.
Cause:
Smaller size paper has smaller width, therefore more of the roller is exposed. This allows a leakage of