Ricoh Pro 8320 - Shift Tray Full Is Disabled; The Side Fences in the Paper Tray Are too Far Apart

3.Paper Delivery Problems
700
The side fences in the paper tray are too far apart.
 If the side fences are too far apart, the paper may shift. Adjust the side fences to match the paper
width.
 When you close the paper tray, the side fences may become misaligned due to the weight of the
paper. Close the paper tray slowly.
The paper size, orientation, and type are not specified correctly.
 In Tray Paper Settings, specify the size, orientation, and type of the paper in use.
Colored paper is loaded in the paper tray.
 It could be that the paper edge was not detected correctly. Adjust color paper edge detection.
1. In Advanced Settings for the custom paper in use, select Color Paper Edge Detection Adjustment
and make a note of the present value. (1341-02)
2. Increase the value in Color Paper Edge Detection Adjustment.
3. Print the image. Is the problem resolved?
Yes
Finished.
No
Keep increasing the value until the problem is resolved.
If the problem persists even though the setting has reached its maximum value, restore
the value noted in Step 1 and go to the next step.
4. In Advanced Settings for the custom paper in use, set Skew Detection to Off.
5. Print the image. Is the problem resolved?
Yes
Finished.
No
Consult the product specialist.
Papers of different type, thickness, or color are loaded in the paper tray.
 Load only one type, thickness, or color.
Shift Tray Full is disabled
When using as a custom paper:
In Advanced Settings for the custom paper in use, disable side-to-side registration. (1101-05)
When not using as a custom paper:
On the Adjustment Settings for Skilled Operators menu, select Machine: Image Position, and
deactivate Image Position Adjustment Across Feed. (SP 1-917-001 to 013: Side-to-Side Reg
Disable Tray <number>)
J050 is issued and corners are folded
Refer to “Frequent Double Feeds, Failure to Feed for the vacuum feed LCT.