Ricoh Pro 8320 - Side-To-Side Registration Error (Finisher Registration Adjustment)

4.Troubleshooting for Peripheral Units
790
If this happens, stapled sheets, when they are delivered, may push the previous delivered sheet,
resulting in paper bending or jam.
This is likely to occur if:
 There is a tight curl on a delivered set of stapled sheets.
 Limp paper such as thin or recycled paper is used.
[A]
Trailing Edges
[B]
Output Tray
[C]
Paper Exit
In the illustration the trailing edges of the stack [A] on the output tray [B] are too close to the paper
exit [C]
Solution:
1. On the Adjustment Settings for Skilled Operators menu, select Machine: Paper Feed/ Output >
Adjust Paper Curl > Set to "Adjust Concave Curl". (SP 1-906-001 to 012: De-curler Setting Tray
<number> :Paper Path Selection)
2. Select "Strong" or "Weak" to control the amount of curl correction as required.
3. Print the image. Is the problem resolved?
Yes
Finished.
No
Consult the product specialist.
Side-to-Side Registration Error (Finisher Registration Adjustment)
A side-to-side registration error occurs when the paper is fed into the finisher.
Solution:
The docking bracket [A] for Booklet Finisher SR5090/Finisher SR5100 [A] (and its screw [B]) can be
used to adjust the side-to-side registration.