4.Troubleshooting for Peripheral Units
820
ï‚· In order to change the position of the front cover plate evenly, the adjustments must be
done at all six points, two on the left side (top and bottom), two on the right side (top and
bottom), and two screws loosened on the top.
4. First, loosen the screws on the top front edge of the tray.
ï‚· If you cannot see the screws, remove the front cover ( x4).
5. At each grid adjustment point, remove each screw [A]. This allows you to easily adjust the position
of the cover so you can align the holes.
6. Fasten the screw into hole [B] for the selected adjustment. Be sure to fasten the screw at the same
To Next Page
Loading...
