4.Troubleshooting for Peripheral Units
824
Image Skewed to the Rear
Measure the amount of skew. This is the difference between A and B.
If the amount of skew (difference between A and B) is 1 mm and there is only one LCIT RT5120 in the
line, insert two shims at the front [A] as shown.
If the amount of skew (difference between A and B) is 1 mm and there are two LCIT RT5120 in the line,
insert two shims at the front [A] as shown on the left side of the upstream LCIT.
To Next Page
Loading...
