5.Other Information
857
3. Move the adjustment plate [A] to the scale [B], and then tighten both screws [C].
Example 1
If the right steering plate was set to "-1" and the SP setting was "+30", move the plate up one notch
(+1) to "0" on the scale.
Example 2
If the right steering plate was set to "+1" and the SP setting was "+30", the position of the plate
cannot be adjusted. You will have to adjust the left steering plate up one notch (+1). If the left
steering plate is at the "0" notch, move the plate up one notch (+1), or of the plate is at +1, move
the plate up two notches (+2).
4. Tighten both screws [A]. Make sure that the plate is at the correction position on the scale. This
completes manual adjustment of the plate.
5. Return to Step 5 in the previous section and restore these SP codes to their default settings.
ï‚· SP 2-920-002 (Steering Control Roller Stable Position of Steering Roller)
ï‚· SP 2-920-004 (Steering Control Roller Last Time Ai Value)
Right Steering Plate Scale Adjustment Example
To Next Page
Loading...
