Output tray
Paper exit
Paper feed direction
CEZ596
Solution:
Depending on the cause of the problem, do one of the following:
<Sheet bending>
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Sheets are curled upward.
<If the decurler unit is used>
1. In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for
Operators] menu, set 0310: [Correct Output Paper Curl] to "U Curl Correction
Level".
To control the level of decurling, select "Small" if the present setting is "Off" or
"Large" if the present value is "Small".
<If the decurler unit is not used>
1. Load the sheets the other way up.
Paper of Paper Weight 0 is being used.
If paper of Paper Weight 0 is being used, attach the Z-fold support tray for multi-folding unit.
For details about attaching the Z-fold support tray for multi-folding unit, see "Preparation"
supplied with the machine.
<One sheet pushing out another or sheets becoming crimped>
Sheets are curled downward.
<If the decurler unit is used>
1. In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for
Operators] menu, set 0310: [Correct Output Paper Curl] to "П Curl Correction
Level".
To control the level of decurling, select "Small" if the present setting is "Off" or
"Large" if the present value is "Small".
Finisher SR5110/Booklet Finisher SR5120
143
To Next Page
Loading...
