Fusing temperature must be adjusted if a fusing error or abnormal luster occurs after three to ten pages
of a multi-page job are printed.
Press [+] to increase the temperature and [−] to reduce it.
Setting Items Max. Value Min. Value Step Unit
[Adjust Adding Fusing Temperature 2] 30 0 1 degree(s)
80: [Paper Feed Interval Setting]
Adjust the interval between the feeding of each sheet.
The standard interval is "100". If you set this to "50", the throughput will be reduced in half.
Press [+] to increase the interval and [−] to reduce it.
• Depending on the fusing unit's temperature and the size of paper, if you increase the interval by
pressing [−], the copy/print speed may decrease.
Setting Items Max. Value Min. Value Step Unit
[Paper Feed Interval Setting] 100 1 1 %
81: [Reduce Initial CPM: Low Temp. Envrnmt.]
Select one of the three levels of copy/print speed reduction at low temperatures.
If the temperature of the fusing unit fall below a certain point, the machine will reduce the copy/print
speed to increase fusibility. You can select from the three levels of copy/print speed reduction.
Pro C5100S
• [Do not Reduce]
65 cpm (full speed)
• [Reduce Level 1]
52 cpm (80% of full speed)
• [Reduce Level 2]
42 cpm (65% of full speed)
• [Reduce Level 3]
32 cpm (50% of full speed)
Pro C5110S
• [Do not Reduce]
4. Details of Menu Items in Advanced Settings
108
To Next Page
Loading...
