1. Create a new folder inside the SD card and name it “package”. Then copy the package
firmware (xxxxxxxx.pkg) to this folder.
• If you copy the package firmware into the conventional “romdata” folder, the update will not
work.
•
Only one version of the package firmware should be copied into the folder. If you copy
multiple versions of package firmware to the SD card, the machine will select only one version
of the firmware randomly.
2. Turn the power OFF.
3. Insert the SD card which contains the package into SD card slot 2 (for service).
4. Turn the power ON and touch [Update].
• When the SD card contains both a firmware package and a module, the following display
may show up. Select [Package] and touch [OK] to move to step 4 above.
Package Firmware Update (D135/D136 only)
853
To Next Page
Loading...
