• No
Default: [Yes]
• Display Time
• At Mode Selected
• Full Time
Default: [At Mode Selected]
• When you select an interposer tray, you cannot change the [Display Time] and [Apply
Duplex] settings.
• When [At Mode Selected] is selected for [Display Time], the [Front Cover] settings only
appear when the front cover sheet function is selected.
• You can specify the [Apply Duplex] settings only when [At Mode Selected] is selected for
[Display Time].
• The lock mark ( ) is displayed next to the paper tray when [Full Time] is selected for [Display
Time].
Back Cover (Back Cover Sheet Tray)
You can specify and display the paper tray in which to load back cover sheets.
You can also specify the display time and copying method for duplex copying.
• Tray to Program
• Tray 1
• Tray 2
• Tray 3
• Tray 4
• Tray 5
• Tray 6
• Tray 7
• Tray 8
• Tray A
• Intpsr. Upper (when the interposer is installed.)
• Intpsr. Lower (when the interposer is installed.)
Default: Off (Tray is not specified.)
• Apply Duplex
• Yes
• No
6. Paper Specifications and Adding Paper
258
To Next Page
Loading...
