• When [At Mode Selected] is selected for [Display Time], the [Slip Sheet] settings only appear
when the slip sheet function is selected.
• The lock mark ( ) is displayed next to the paper tray when [Full Time] is selected for [Display
Time].
Sep. Sheet (Separation Sheet Tray)
You can specify and display the paper tray in which to load separation sheets.
You can also specify the display time.
• Tray to Program
• Tray 1
• Tray 2
• Tray 3
• Tray 4
• Tray 5
• Tray 6
• Tray 7
• Tray 8
• Tray A
• Intpsr. Upper (when the interposer is installed.)
• Intpsr. Lower (when the interposer is installed.)
Default: Off (Tray is not specified.)
• Display Time
• At Mode Selected
• Full Time
Default: [At Mode Selected]
• When you select an interposer tray, you cannot change the [Display Time] setting.
• When [At Mode Selected] is selected for [Display Time], the [Sep. Sheet] settings only appear
when the separation sheet function is selected.
• The lock mark ( ) is displayed next to the paper tray when [Full Time] is selected for [Display
Time].
Desig. Sheet 1–11 (Designation Sheet 1–11 Tray)
You can specify and display the paper tray in which to load designation sheets.
You can also specify the display time and copying method for duplex copying.
6. Paper Specifications and Adding Paper
260
To Next Page
Loading...
