Ricoh PRO C7210X - Page 113

1.SC Codes
109
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Triac shorted.
 IOB board defective.
 Fuser Unit controller software runaway
 Replace the AC drive board.
 Replace the IOB board.
 Replace the Fuser Unit.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC568-
00
A
Hardware High temperature detection: Heating Roller Thermostat - Center
(Sensor 11)
Occurs when the sensor 11 detects a temperature of 270°C.
 Triac short circuit
 IOB defective
 BCU defective
 Fusing out of control
 Replace the AC drive board.
 Replace the IOB.
 Replace the IOB.
 Replace the fuser unit.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC569-01
SC569-02
SC569-03
D
Pressure Release Error: Pressure Roller Cam Position Sensors (A / B)
 SC569-01
Pressure release/Home position/control failed 3 times consecutively.
 SC569-02
Failure for pressure release control is detected (SC occurs even once).
 SC569-03
Pressure release sensor B shows High.
 Pressure release motor defective
 Pressure release sensor defective
 Pressure release mechanism defective
 SC569-01/-02
Replace the pressure roller lift motor.
Replace the Pressure Roller Cam Position Sensors.
Replace the feeler.
Replace the Fuser Unit.
 SC569-03