Ricoh PRO C7210X - Page 140

1.SC Codes
136
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
43
SC682-
44
D
PCU: ID Chip Communication Error (Y_ verify error)
SC682-
45
D
PCU: ID Chip Communication Error (S_ verify error)
When error notification was received during communication with the tag and
operation is not resumed after 3 retries.
There was an error during (wired) communication with the ID chip on the toner
bottle.
 PCU set error
 Harness broken
 BCU damaged
 IOB damaged
 Unintended noise
 Cycle the machine off/on
 Set the PCU again.
 Reconnect the harness between BCU and TD sensor (HST sensor).
 Replace the PCU.
 Reconnect the IOB connector
 Replace the harness between BCU and TD sensor (HST sensor).
 Replace the BCU.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC683-
03
B
CIS error 2: registration: serial communication error: front CIS
SC683-
07
B
CIS error 2: registration: connection detection error: front CIS
SC683-11
B
CIS error 2: registration: black level adjustment error: front CIS
When turning on the power, recovering from energy saving, and the door is
closed
 SC683-03: Communication error between CIS right and IOB
 SC683-07: Connection error between CIS right and CRB
 SC683-11: CIS right black level adjustment error
When printing
 SC683-15: CIS right black level error
 Harness disconnected
 Harness defective/shortened