Ricoh PRO C7210X - Page 205

1.SC Codes
201
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Slave Control Board defective
 Reconnect the connector.
 Replace the glue supply fan (high).
 Replace the slave board.
 Replace the motor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
36
D
Perfect Binder: Glue supply fan L lock error
Glue supply L fan failed to generate a lock signal within 12 sec., and signal could
be detected even after a re-try.
 Glue supply fan L overloaded, defective
 Slave Control Board defective
 Reconnect the connector.
 Replace the glue supply fan L.
 Replace the slave board.
 Replace the motor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
37
D
Perfect Binder: Grip HP sensor lag error
During operation of the grip unit the HP sensor did not OFF after grip unit moved
20 mm.
 Grip motor defective, grip HP sensor defective, overload, sensor flag
defective, connector broken defective
 Reconnect the connector.
 Replace the grip motor.
 Replace the grip HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
38
D
Perfect Binder: Grip HP sensor late error
The HP sensor did not go ON after the grip unit released the signature and
moved 76 mm.
 Grip motor defective, Grip end sensor defective, overload, Sensor flag
defective, connector broken defective
 Reconnect the connector.