Ricoh PRO C7210X - Page 213

1.SC Codes
209
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
degrees.
 The book rotation HP sensor did not go OFF after the book was rotated 30
degrees.
Book rotation motor 1 (right) defective, Book rotation HP sensor (right) defective,
overload, disconnected, book jam
 Reconnect the connector.
 Replace the book rotation motor 1 (right)
 Replace the book rotation HP sensor (right)
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
58
D
Perfect Binder: Book rotation HP sensor (right) late error
 The book rotation HP 1 (right) sensor did not go ON after the book was
rotated 440 degrees.
 The book rotation HP 1 (right) sensor did not go ON after the book was
rotated 400 degrees.
 The book rotation HP 1 (right) sensor did not go ON after the book was
rotated 360 degrees.
Book rotation motor 1 (right) defective, Book rotation HP sensor (right) defective,
overload, disconnected, book jam
 Reconnect the connector.
 Replace the book rotation motor 1 (right)
 Replace the book rotation HP sensor (right)
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
59
D
Perfect Binder: Book rotation HP sensor (left) lag error
 The book rotation HP sensor 2 (right) did not go OFF after the book was
rotated 50 degrees.
 The book rotation HP sensor 2 (left) did not go OFF after the book was
rotated 50 degrees toward the cutting position.