• 1231-12: Print Speed: FCS: Fuser Setting HQ: White
• 1231-13: Print Speed: FCS: Fuser Setting HQ: Metallic
• 1231-15: Print Speed: S: Fuser Setting HQ: Clear/Special
• 1231-16: Print Speed: S: Fuser Setting HQ: White
• 1231-17: Print Speed: S: Fuser Setting HQ: Metallic
• You can reduce the vibration of the intermediate transfer roller by decreasing the print speed,
but doing so also reduces throughput.
• If set to "Middle", throughput is reduced to 85% of that when set to "High".
5. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
6. Set the value in the following corresponding settings to [Low].
• If set to "Low", throughput is reduced to 50% of that when set to "Middle".
7. Print the image. Has the problem been resolved?
Yes Finished!
No No further improvement is likely.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
5. Image Quality Problem: Lines/Streaks
148
To Next Page
Loading...
