Solutions: If printing an original that has solid-fill images at the trailing edge of a page
and half-tone images at the leading edge of the next page
1. Can you rotate the original by 90 or 180 degrees?
• A: Rotation by 90 degrees
• B: Rotation by 180 degrees
Yes Rotate the original by 90 or 180 degrees.
No Proceed to Step 3.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. If the paper is not registered as custom paper, register the brand of the paper.
4. In [Detailed settings] for custom paper, select 1237: [Print Speed (Sheet Interval Adj)],
and then adjust the interval between sheets according to the mode used.
• 1237-01: Print Speed (Sheet Interval Adj): BW/FC/FCS: BW/FC/FCS
• 1237-02: Print Speed (Sheet Interval Adj): FCS: Clear/Special
• 1237-03: Print Speed (Sheet Interval Adj): FCS: White
• 1237-04: Print Speed (Sheet Interval Adj): FCS: Metallic
• By increasing the interval between sheets, the banding position can be shifted from the
halftone area on the next page. However, throughput will be reduced due to the increased
interval between sheets.
Bands
149
To Next Page
Loading...
