5. Print the image. Has the problem been resolved?
Yes Finished!
No No further improvement is likely.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
Banding at Random Pitch (Metallic Paper)
When printing is performed on metallic paper, white streaks 5 to 40 mm (0.2 to 1.6 inches) long
appear all over the paper perpendicular to the paper feed direction.
Cause:
The surface of metallic paper is of very low resistance and the paper transfer current tends to be
transferred on the paper surface to nearby parts. As a result, due to the lack of necessary transfer bias,
banding at random pitch occurs.
Solutions:
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for the custom paper you are using, select 1214: [Paper Transfer
Output], and then adjust the values in the following settings in steps of ±1 according to the
mode in use.
• 1214-01: Paper Transfer Output: BW: Side 1
• 1214-02: Paper Transfer Output: BW: Side 2
• 1214-05: Paper Transfer Output: FC/FCS: Side 1
5. Image Quality Problem: Lines/Streaks
150
To Next Page
Loading...
