Ricoh Pro C7500 - Page 89

3. Set the value in the following corresponding settings to 5°C.
Productivity Priority
• 1232-03: Fusing Temperature: BW/FC/FCS: Correct Temp: Pre-Feed
• 1232-14: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Clear/Special
• 1232-15: Fusing Temperature: FCS: Correct Temp: Pre-Feed: White
• 1232-16: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Metallic
• 1232-34: Fusing Temperature: S: Correct Temp: Pre-Feed: Clear/Special
• 1232-35: Fusing Temperature: S: Correct Temp: Pre-Feed: White
• 1232-36: Fusing Temperature: S: Correct Temp: Pre-Feed: Metallic
High Quality
• 1232-48: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Pre-Feed
• 1232-59: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/
Special
• 1232-60: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-61: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
• 1232-79: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Clear/Special
• 1232-80: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: White
• 1232-81: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Pre-Feed: Metallic
4. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Proceed to Step 7.
No Go to the next step.
5. Go back to 1232: [Fusing Temperature] and decrease the fusing heat roller's temperature
by 5°C.
6. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Go to the next step.
No Start over from Step 5.
7. Is the toner fusibility within the permissible range?
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
Uneven Density
87