Solution:
1. On the printer driver dialog box of Fiery Command WorkStation, set the fusibility
throughput setting to Fuser Setting HQ mode.
• When using paper with a thickness of Paper Weight 6 to 9, throughput may be reduced.
Print 10 or more A3 sheets. Has the problem been resolved?
Yes Finished!
No Go to next step.
2. If the paper is not registered as custom paper, register the brand of the paper.
3. If there is room to reduce the print speed (from "High" or from "Middle"), and if the
reduced throughput does not cause a problem, go to the next step.
Otherwise, perform the procedure from Step 5 in "(b) Changing the fusing temperature (If [Print
Speed] is set to [Low])".
4. In [Detailed settings] for the custom paper you are using, select 1231: [Print Speed], and
then decrease the value in the following corresponding settings by one level.
Productivity Priority
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
High Quality
• 1231-10: Print Speed: BW/FC/FCS: Fuser Setting HQ: BW/FC/FCS
• 1231-11: Print Speed: FCS: Fuser Setting HQ: Clear/Special
• 1231-12: Print Speed: FCS: Fuser Setting HQ: White
• 1231-13: Print Speed: FCS: Fuser Setting HQ: Metallic
• 1231-15: Print Speed: S: Fuser Setting HQ: Clear/Special
• 1231-16: Print Speed: S: Fuser Setting HQ: White
• 1231-17: Print Speed: S: Fuser Setting HQ: Metallic
If the present value is [High], select [Middle]. If it is [Middle], select [Low].
Uneven Density
89
To Next Page
Loading...
