4. Click [PANTONE+ Metallics Coated] under "Group".
5. Specify "Output Profile".
Use the specified profile in the print setting.
6. Check that "Special" is displayed in "Specialty colors", and then turn it on by moving the
toggle switch to the right.
If "Special" is not displayed, check that the silver toner is set correctly on the machine. "Special" is
also displayed also when the gold toner is set on the machine. If you are uncertain of the type of
toner set on the machine, check that the silver toner is set.
Registering the Setting Values of the Metallic Color in Fiery Command WorkStation
11
To Next Page
Loading...
