T
echnical
B
ulletin PAGE: 3/3
Model:
Aries-P1.5
Date:
04-Apr-13
No.:
RM077089
5. Select “Advanced Setting”. (Photo 5)
6. Select “Fusing Heat Roller Temperature Adj” and change the fusing temperature with
the “+” and “–“ buttons. It is recommended to decrease the temperature about 10
degrees from the default temperature. (Photos 6 & 7)
Photo 5 Photo 6
Photo 7
Tips
1) If glossy lines/streaks do not disappear even after decreasing the temperature about 10
degrees, decrease the temperature more. However, if this results in insufficient fusing,
increase the temperature in 5-degree increments and check that no glossy
lines/streaks are observed on the printouts.
2) It is recommended to note the original (default) fusing temp before making any
changes as you may have to switch back to the original stripper plate (p/n: M0774491)
if the glossy lines/streaks generated with the new stripper plate (p/n: M0774445)
cannot be resolved.
To Next Page
Loading...
