Technical Bulletin PAGE: 75/75
Reissued:21-Apr-14
5. Select “Advanced Setting”. (Photo 5)
6. Select “Fusing Heat Roller Temperature Adj” and change the fusing temperature with
the “+” and “–” buttons. Decrease the temperature about 10 degrees from the default
temperature. (Photos 6 & 7)
Photo 5 Photo 6
Photo 7
Tips
1) If gloss lines/streaks do not disappear even after decreasing the temperature, further
decrease the temperature. However, if resulting in insufficient fusing, increase the
temperature 5 degrees and check if gloss lines/streaks are observed on the printouts.
2) Take notes of the original (default) fusing temp before making any changes because
you may have to switch back to the original stripper plate (p/n: M0774491), if gloss
lines/streaks with the new stripper plate (p/n: M0774445) cannot be resolved.
To Next Page
Loading...
