1. Carefully pull out the paper tray until it stops.
1. Paper transfer unit
Do not open the paper transfer unit when the paper tray is in use, or a misfeed might occur.
2. Release the end fence.
3. Loosen the screws holding the side fences in position.
4. Load paper by aligning the paper with the left side of the paper tray.
Place paper with print side up.
Load a stack of paper about 5 - 10 mm (0.25 - 0.4 inches) high.
2. Adding Paper, Toner, Staples, Rings and Glue
44
To Next Page
Loading...
