6. When adjusting the paper tray for custom size paper, pull up on the end fence to secure it
at the required position.
7. Square the paper, and then load it print side down.
Re-lock the side fences again.
8. Carefully slide the paper tray fully in.
9. Check the size on the display.
Changing the Paper Size in the Large Capacity Tray
This section explains how to change the paper size in the LCT.
• To change paper sizes of Tray 5, contact your service representative.
• Check that the paper edges are aligned at the left side.
• Do not stack paper over the limit mark.
2. Adding Paper, Toner, Staples, Rings and Glue
62
To Next Page
Loading...
