• Remove the Z-fold support tray when delivering copies to the finisher shift tray without using the Z-
fold function. If you leave the Z-fold support tray in place, prints are not stacked properly.
Ring Binding
You can punch holes into copies and bound them by ring comb.
• Before using this function, select the binding and punch hole positions shown on the [Finisher] tab
under Finisher: Ring Binding Type in Input / Output. For details, see “Copier/Document Server
Features”, General Settings Guide.
• The following copier functions are not available when ring binding output:
• Booklet/Magazine
• Stack
• Shift tray off in sort/stack
• Slip Sheet
• Separation Sheet
• Z-fold
• Copy Face Up
• Staple/Staple (Center)
• Punch
• Eject copies to the stacker
• Perfect Binding
Finishing
103
To Next Page
Loading...
