• You can adjust the position of the fore edge cut from 6 to 50 mm (0.24 to 1.96 inches) in 0.1 mm
(0.01 inch) increments.
Specifying the finishing size
Specify the size of the finished bound booklets to determine the position where you want to cut the fore
edge.
1. Press [Cut Fore Edge].
2. Press [Specify Finishing Size].
3. Enter the required finishing size using the number keys, and then press [ ].
To change the value you entered, press [Clear] and then enter a new value.
4. Press [OK] twice.
• You can adjust the finishing size from 139.7 to 216 mm (5.50 to 8.50 inches) in 0.1 mm (0.01 inch)
increments.
Specifying the three edge cut
Use the following procedure to specify the three edge cut when perfect binding is applied.
2. Basic Copying
112
To Next Page
Loading...
