Centering
• Though the original is set to a different orientation from the paper loaded, the machine will not
rotate the image by 90 degrees (Rotate copy).
Booklet/Magazine
• The machine sets the reproduction ratio automatically to meet the paper size and copies the
originals together onto the paper.
• The reproduction ratios selectable by the machine are 25 400%.
• If the calculated ratio is under the minimum ratio, it is automatically adjusted to within available
range. However, with some ratios, parts of the image might not be copied.
• If the orientation of originals is different from that of the copy paper, the machine will
automatically rotate the image by 90 degrees to make copies properly.
• You cannot copy with originals different in size and orientation.
• If the number of originals scanned is less than a multiple of 4, the last page is copied blank.
• In Magazine mode, the copying may take some time after scanning originals.
• When the Booklet Finisher SR5020 is installed, if you select Staple: Center in Magazine mode,
the machine staples and folds the paper in the center, then delivers the paper folded.
• If you are using this function with the interposer and have specified Staple: Center, load cover
sheets face down in the interposer.
Covers
• If Blank mode is selected, the cover will not be counted as a copy.
• The settings made under Front Cover Sheet and Back Cover Sheet in Tray Paper Settings
determine whether or not the front and back covers are duplex printed.
• At Mode Selected... Settings made in Front Cover Sheet and Back Cover Sheet will take
priority.
• Full Time... Settings made in Paper Type will take priority.
Supplementary Information
263
To Next Page
Loading...
