1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2. Load paper into the paper tray with print side up.
Do not stack paper over the limit mark.
3. Carefully push the paper tray fully in.
• Various sizes of paper can be loaded in Trays 1, 2, and the wide LCT by adjusting the positions of
side fence and end fence. For details, see page 109 "Changing the Paper Size in Trays 1, 2, and
the Wide Large Capacity Tray".
• You can load envelopes in Trays 1, 2, and the wide LCT. When loading envelopes, place them in
the correct orientation. For details, see page 132 "Envelopes".
• When using auto tray switching, covers, or slip sheets, the lamp on the front of the tray being used
will stay lit until printing is complete. While the lamp is lit, paper cannot be replenished.
Attaching the small tab end fence to Trays 1, 2, and the Wide Large Capacity Tray
When loading the following paper, attach the small tab end fence:
• B5 (width: 182 mm, length: 257 mm)–SRA4 (width: 225 mm, length: 320 mm) of paper
weight 8
5. Paper Specifications and Adding Paper
100
To Next Page
Loading...
