• The maximum number of sheets you can load at the same time depends on paper type. Do not
stack paper over the limit mark. For the maximum number of sheets you can load, see page 119
"Recommended Paper Sizes and Types".
• Check the paper edges are aligned at the left side.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease, the paper may
misfeed, or if it weighs between 52.3–63.0 g/m
2
(14.0–16.9 lb. Bond), it may wrinkle.
1. Set the side fences to the paper size, and then square the paper and load it print side up.
Do not stack paper over the limit mark.
2. Set the end fence.
1. End fence
2. Extender
To remove the end fence, slide it to the right by pressing the stopper down.
5. Paper Specifications and Adding Paper
102
To Next Page
Loading...
