2. Pull out the output holding unit for letter fold-out.
When you have finished using the Z-fold support tray for multi-folding unit and the output holding
unit for letter fold-out, return each to their previous positions.
To deliver an envelope of 240 × 332 mm
When sending an envelope of 240 × 332 mm to Finisher SR5050 or Booklet Finisher SR5060,
attach the Z-fold support tray to the finisher shift tray.
1. Attach the Z-fold support tray by inserting the two protrusions on its underside into
the holes on the finisher shift tray.
• Prints may not stack properly when the Z-fold tray is attached.
4. Getting Started
64
To Next Page
Loading...
