• If multiple sheet feeding occurs, fan sheets thoroughly or load sheets one by one from the multi
bypass tray (Tray A).
• You can specify whether or not the machine auto detects multi-sheet feeds in paper from every tray.
In [Detect JAM099] under the [Adjustment Settings for Operators], you can also specify whether
current jobs are suspended or continued when a multi-sheet feed is detected. However, depending
on the condition of the paper, the machine may not detect a multi-sheet feed correctly. For details
about Adjustment Settings for Operators, see page 177 "0304 Detect JAM099".
• Flatten out curled sheets before loading them.
• The Adjust Paper Curl function might not be able to fully remove curl, depending on the type of
paper and the direction of its grain. If long grain paper does not uncurl properly, try short grain
paper instead. For details about the Adjust Paper Curl function, see page 175 "0301 Correct
Output Paper Curl: 1 Sided: Face Up", page 176 "0302 Correct Output Paper Curl: 1 Sided:
Face Down", page 176 "0303 Correct Output Paper Curl: 2 Sided".
• Depending on the paper's size, paper weight or paper type, the print speed may be slower than
usual.
• When loading envelopes, see page 132 "Envelopes".
• When printing onto letterhead paper, the paper placing orientation is different depending on
which function you are using. For details, see page 107 "Loading Orientation-fixed Paper or Two-
sided Paper".
• The paper types you can select in Tray Paper Settings are only general classifications. Print quality
for every kind of paper in a classification is not guaranteed. For details, see page 135 "Unusable
Paper".
• If the surface of the paper is dusty, white spots might appear on prints. To remove dust, fan the
paper thoroughly.
• When loading label paper:
• Select [Label Paper] for [Paper Type] in [Tray Paper Settings], and select an appropriate
paper weight under [Paper Weight].
• When loading transparencies:
• To print on transparencies, select [Transparency] for [Paper Type] in [Tray Paper Settings].
• When you load transparencies, check the front and back of the sheets, and place them
correctly, or a misfeed might occur.
• Fan transparencies thoroughly whenever you use them. This prevents transparencies from
sticking together, and from feeding incorrectly.
• Remove printed sheets one by one.
• When outputting to the high capacity stacker, specify the output tray as the stacker upper tray.
For details, see "General Features", Device Management.
• When loading translucent paper:
5. Paper Specifications and Adding Paper
130
To Next Page
Loading...
