• You can install the trimmer only if Booklet Finisher SR5060 is installed.
• You cannot install the ring binder and perfect binder simultaneously.
• The multi bypass tray (Tray A) can be attached only if the wide LCT is installed. However, you can
attach the multi bypass tray (Tray A) to the wide LCT only if the multi bypass attachment kit is
installed.
Removing prints from finisher during printing
This section describes how to suspend a print job when using the finisher.
Depending on the image you are printing, prints might not stack properly. If this happens, suspend the
job, remove the prints and then restart the job.
1. Press the [Suspend / Resume] key.
1. [Suspend / Resume] key
2. Remove the stack of paper from the finisher shift tray.
3. Press the [Suspend / Resume] key to restart the print.
• You can suspend printing only when the finisher shift tray is selected as the output tray.
Guide to Functions of the Machine's Options
61
To Next Page
Loading...
