When using the Z-fold function
To use the Z-fold function, you must attach the Z-fold support tray.
Finisher SR5050 and Booklet Finisher SR5060
• Finisher shift tray
Attach the Z-fold support tray by inserting the two protrusions on its underside into the holes
on the finisher shift tray.
Multi-folding unit
1. Lift up and slide the Z-fold support tray for multi-folding unit to the right, and then set
it in place.
When you have finished using the Z-fold support tray for multi-folding unit, lift it up and slide
the tray to the left, and then lower it.
4. Getting Started
62
To Next Page
Loading...
